CNP90TV-F/MF coaxial surge protector for video transmission networks

Reference price :

Select a product to request a quote

CNP90TV-F/MF coaxial surge protector for video transmission networks

Name: CNP90TV-F/MF coaxial surge protector for video transmission networks
Brand: CITEL
SKU: CNP90TV-F/MF
Availability: InStock
Rating: 5 (1 reviews)

Series

CNP
Model

CNP90TV-F/MF
Brand / Made in

CITEL / FRANCE

Coaxial surge protector for video transmission networks
Network: coaxial DC-1 GHz
Power: 25 W
Connectors: F male/female
Technology: Gas discharge tube
Max. discharge current: 20 kA
Low insertion loss
Bi-directional protection
Standards compliance: IEC 61643-21 / EN 61643-21 / UL497C / UL497E

CNP series (GDT protection)

CNP protectors are based on GDT to provide high discharge current capability without destruction. These type of products allows for installation in ungrounded systems. In these cases, the CNP isolates the shield from the earth ground and is typically found in applications including wireless radio terminals and TV monitors (antenna, cable or satellite).

Product specifications

Product specifications
product manual
Download file

ELECTRICAL PROPERTIES

Description: Coaxial SPD for video transmission networks
Technology: Gas discharge tube
Frequency range f: DC-1GHz
Max Power P: 25 W
Impedance Z: 50/75 ohms
Insertion loss: < 0.6 dB
Return loss: > 20 dB
VSWR: < 1.35:1
Max. Load current IL: 0.5A
Nominal discharge current In: 5 kA
Max. discharge current Imax: 20 kA
Impulse current Iimp: 2.5 kA
Protection level Up: < 600 V
End of life behavior: Short-circuit (fault mode 2 - Transmission interruption)

MECHANICAL PROPERTIES

Dimensions: see diagram
Connection to Network: Connector F Male/Female
Disconnection indicator: transmission interrupt
Mounting: on plate
Operating temperature: -40/+85°C
Protection rating: IP20
Housing material: Metal+plastic

NORMS

Standards compliance: IEC 61643-21 / EN 61643-21 / UL497C / UL497E

INSTALLATION, LOCATION OF THE SPD

The efficiency of coaxial protectors is highly dependent on proper installation, in particular their connection to the earthing network of the installation.
The following installations rules must be strictly observed to ensure the efficiency:

Equipotential bonding network: all the bonding conductors of the installation must be interconnected and connected to the installation earthing network.
Optimized connection of the protector to the bonding network: to reduce the residual voltages during lightning discharge currents, the connection of the protector to the bonding network must be as short as possible (less than 50 cm) and has a proper cross section (at least 4 mm²).

The «feedthrough mounting» versions perfectly meet all these requirements.
Warning: Carefully remove all paintings or insulating coatings to ensure good contact..

Location of the protectors: they should preferably be placed at the entrance of the installation (to limit the penetration of lightning currents) and also near sensitive equipment (to enhance protection).