• Series
    PL
  • Model
    PL24-CAT6
  • Brand / Made in
    CITEL / FRANCE
  • Surge protector for CAT6
  • 24 ports
  • 19'' patch panel 1 U
  • 100/1000/10Gigabit Ethernet network compliance
  • Connectors RJ45 shielded
  • Bi-directionnel

The PLx-CAT6 are surge protection devices in 19" format and offer protection against lightning and surge voltages for sensitive interfaces connected in a Gigabit Ethernet network. The protection circuit consists of a highly efficient combination of 3-pole gas arresters and low-capacitance diodes. The protection components are connected via standard RJ45 plugs. Up to 24 ports can be protected with the PL24-CAT6. The 19'' format allows easy installation in all standard 19'' cabinets.

ELECTRICAL PROPERTIES

  • Network: 10 Gigabit Ethernet, Cat.6 cabling
  • Nominal line voltage Un: 5 Vdc
  • Max. DC operating voltage Uc: 8 Vdc
  • Max. frequency    f max.: 250 MHz
  • Max. data rate: 10/100/1000 Mbps
  • Insertion loss: < 1 dB
  • Max. load current IL: 1000 mA
  • Protection level Up: 20 V
  • Max. capacitance C: < 25 pF
  • Impulse current    Iimp: 500 A
  • Line/Line Nominal discharge current In L/L: 500 A
  • Line/Ground Nominal discharge current In L/PE: 2000 A

MECHANICAL PROPERTIES

  • Technology: GDT+Clamping diode
  • SPD configuration: 24 ports de 8 wires
  • Connection to Network: RJ45 shielded female input/output
  • Format: Rack 19 inch
  • Mounting: Baie 19 inch
  • Housing material: Aluminium
  • Operating temperature: -40/+85°C
  • Protection rating: IP20
  • Outdoor application: No
  • Failsafe mode: Short-circuit
  • Disconnection indicator: Transmission interrupt
  • Spare module(s): 12-port PCB
  • Remote signaling of disconnection: No
  • Pinout: (1-2)(3-6)(4-5)(7-8)
  • Dimensions: See diagram

NORMS

  • Standards compliance: IEC 61643-21 / EN 61643-21 / UL497 B / IEEE 802-3an
INSTALLATION

The surge protector for IT networks must be installed while respecting the following principles:

  • SPDs must be installed on the both sides of the transmission line (e.g. server side and terminal equipment side)
  • The surge protector and the protected equipment must be interconnected with the bonding network of the installation.
  • The earthing conductor (between the earth output of the SPD and the bonding circuit of the installation) must be as short as possible (less than 0.5m).
  • The AC power supply of the equipment must also be surge protected.
closet

CART

No products in your cart
Báo Giá Sản Phẩm