Hotline:

Category

Lightning protection system for Deep C Hai phong

Category

Industry
Location

Dinh Vu industrial area, Hai Phong City
CHỦ ĐẦU TƯ

DEEP C BLUE HAI PHONG LIMITED COMPANY
NGÀY THỰC HIỆN

2019
SỐ LƯỢNG SẢN PHẨM

ESE; Terrastat Dissipation Terminals; AC SPDs, LAN SPDs and Signal lines & Camera SPDs
TRẠNG THÁI DỰ ÁN

The Project had finished

Description

Lightning protection system to protect for Waste Water Treatment Plant

Location of installation site: Waste Water Treatment Plant TP of Dinh Vu Industrial Zone at Dong Hai 2 Ward, Hai An District, Hai Phong City

The surge & lightning protection system for DEEP C BLUE Hai Phong has been installed by TAEC since 2019. The handover has been excuted and the system has remained stable over a period of years.

The following items were supplied:

Outside lightning protection system was including of Dat Controler Plus ESE with big protection radius.
Otherwise providing Terrastat Dissipation Terminals. The system is to mitigate direct lightning strikes to protect for camera on the mast and outdoor control cabinets
AC Type 1/Type 2 Surge Protection Devices, and parallel AC surge protection cabinets to protect for the entire area electrical network and branch panels.
RJ45 surge protector for POE++ to protect for Camera.
Signal Surge protection devices to protect for sensors and controls panels of water treament
LAN Surge Protection Devices
Earthing system applying for SPD and ESE.

Installation images at DEEP C Hải Phòng

TerraStat Dat Controler ESE and Terrastat Dissipation Terminals

Surge Protection System is istalled in wastewater treatment center DEEP C

Thi công lắp đặt hệ thống chống sét trực tiếp và lan truyền, tiếp đất cho DEEP-C

Go back

Location

Products Used

TerraStat TS400-SS-24 Charge Dissipation Terminal

Model: TS400-SS-24

Patented Technology
High grade stainless steel construction
Lightweight and easy to install
Corrosion resistant
Low wind loading
Large selection of mounting hardware
UL® Listed and recommended as per API 2003
Independently tested

Dat Controler Plus 60 (AT-1560) ESE lightning air terminal

Model: AT-1560

Advance time: 60µs obtained according to UNE21186:2011 tests.
AENOR product certification.
Withstand current higher than 200kA (10/350µs wave).
Certificate of performance under rain (Insulation > 95% according to EN 60060).
No external power supply required.
Protection radius up to 120 meters according to NF C 17102 and UNE21186.
Certificate of use in explosive atmospheres (ATEX).
Manufactured according to ISO 9001 and following ISO 14001 environmental management standard.

DS254VG-300/G Type 1+2+3 AC surge protector - 3-phase+N, 25kA / 70kA

Model: DS254VG-300/G

Type 1+2+3 unipolar surge protector
25 kA on 10/350µs impulse
Low voltage Up
Internal disconnection, status indicator and remote signaling
Optimized to TOV
IEC 61643-11 and UL1449 ed.5 compliance

DS254E-400 Type 1+2 AC surge protector - 3-phase+N

Model: DS254E-400

Type 1 + 2 unipolar surge protector
Iimp total: 100 kA on 10/350µs impulse
Imax : 140 kA on 8/20µs impulse
Internal disconnections, status indicators
Remote signaling
IEC 61643-11, EN 61643-11 and UL1449 ed.5 compliance

DS74R-400 Type 2 AC surge protector - 3-phase+N

Model: DS74R-400

Description: Type 2 AC surge protector - 3-phase
Standards compliance: IEC 61643-11 / EN 61643-11 / UL1449 ed.5
Certification: CSA /EAC/UL
Technology: MOV
SPD configuration: 3-phase+Neutral
Remote signaling of disconnection: option DS74RS-400 : output on changeover contact
Network: 230/400 V 3-phase+N
AC system: IT
Max. AC operating voltage : 440 Vac
Residual Current : < 4 mA
Max. discharge current by pole : 70 kA
Total Maximum discharge current : 280 kA
Admissible short-circuit current: 25 000 A

M50F-230S-A Type 2 single-phase parallel AC surge and filter protection panel

Model: M50F-230S-A

System voltage: 230 V
System: 2W+G (single)
Hybrid MOV-GSG Technology and EMI/RFI filtering
UL1449 Type 2 LISTED
50kA Surge Current Rating per mode
Extended life with no leakage current
Visual LED fault indicator and audible alarm
NEMA 6: indoor / outdoor used
Hardwired connection

DS220-12DC Type 2 12Vdc surge protector 2-pole

Model: DS220-12DC

DC power surge protector
12 Vdc
Compact design
Imax : 20 kA
Pluggable module
Very low Up protection level

MJ8-POE-C6A surge protector for PoE++ and 10Gb Ethernet

Model: MJ8-POE-C6A

POE++ compatible
Gigabit Ethernet (Cat.6A)
Shielded enclosure and connectors
2 kA discharge capability
UL497B certified
IEC 61643-21, EN 61643-21 compliance

PL24-CAT6 19" patch panel surge protector for 24 ports 10Gb Ethernet

Model: PL24-CAT6

Surge protector for CAT6
24 ports
19'' patch panel 1 U
100/1000/10Gigabit Ethernet network compliance
Connectors RJ45 shielded
Bi-directionnel

DLA-12D3 1-pair DIN-rail plug-in Data surge protector for RS232, RS485

Model: DLA-12D3

Din rail plug-in surge protector
1-pair
Un: 12 V
Shield wire protection
Plug-out without line cut-off
IEC 61643-21 compliance
UL497A

LSC-A digital lightning current counter

Model: LSC-A

Lightning current For LPS and SPD

Outdoor or indoor application
Minimum current sensibility: 0.5 kA
Max. admissible impulse current: 100 kA
Maximum numbers of events: 999999
Type d’affichage: LCD
Dimensions: 66 x 55 x 47 mm, Weight: 0,14 kg
Enclosure: Thermoplastic UL94-V0
Power supply: internal by battery
Life expectancy (before battery replacement): > 10 years
Mounting: by flange on round (diam. 10-16mm) or flat (30 x2mm) conductor or DIN rail
Protection rating: IP67
Compliance: EN 62561-6

CONDUCTIVER PLUS AT-10L Ground Enhancing Gel

Model: AT-010L

Non-corrosive and ecological gel that improves soil conductivity
Low solubility, very hygroscopic
Its capacity to create partially ionized electrolytes, with a high charge and capacity to retain water and form gels
Remaining in the ground for a long time, thanks to the formation of bonds with the particles
Increasing the conductivity of the ground for one year (considering rainfall of 700 litres/m2)
Not causing corrosion of the earth electrod
Being totally ecological
Dimensions: ø225 x 185 mm
Materials: Polypropylene (container)
Weight: 4200 g
Standards: Complies with UNE 21186, NF C 17-102, IEC 62305

AT-050K spark gap for earth bonding

Model: AT-050K

Dimensions: 216 x 55 x 38 mm
For tape: 30 x 2 - 30 x 3.5 mm
For cable (diameter): 8 - 10 mm
For cable (section): 50 - 70 mm²
Material/s: Polyurethane resin
Weight: 910 g
Includes: 2 x AT-020F (square tape & cable clamp)
Lightning impulse current (10/350µs wave): > 100 kA
Nominal discharge current: 50 kA
Protection level 1.2/50µs wave): < 4 kV
Working temperature: 55 ºC to + 85 ºC
Standards: Complies with UNE 21186, NF C 17-102, IEC 62305

APLIWELD-T exorthemic welding compound in tablet form

Model: AT-020N

Reference: AT-020N
Packaging dimensions: 52 x 52 x 220 mm
Total weight: 900 g
Units per pack: 20 tablets
Tablet dimensions: 43 mm
Compact and easy to use
Reduces stock costs
Improves welding process times
Increases equipment life-time
Both electronic and powderstarters can be employed
Certification in agreement with UL467 Grounding and bonding equipment
Compliance with NTP 1028 safety in copper aluminothermic welding
Compliance with ITC-BT-26 internal housing installations. General installation requirements